The ADF setting up will need to be eliminated initially to obtain the flatbed scanner out. When you eliminate the ADF device you not make use of the ADF cord that is affixed to the device to raise or relocate. When eliminated it ought to be positioned on a flat degree surface area.
1). Transform the printer off and also eliminate the power cable develop the printer.
2). While dealing with the rear of the printer you will certainly see the ADF cord originating from the rear of the ADF to the scanner control panel. There are 2 screws that require to be eliminated on the cover to access the scanner control panel. When the cover is eliminated there is a basing screw that should be eliminated. Currently both cable televisions can be separated. Prior to getting rid of the cord keep in mind of the means the cord is directed with the cord owner right into the scanner bed.
3). Open up the ADF setting up like you were mosting likely to make a duplicate on the flatbed scanner and also raise the ADF off of the scanner. The ADF setting up has actually been adjusted to collaborate with the scanner on which it is mounted. If you were to change the ADF device or mount it on an additional flatbed scanner, that scanner will certainly need to be adjusted to keeping that ADF.
4). Elevate the scanner setting up to the up placement. While dealing with the front of the printer, you can currently eliminate the leading edge flange. This item stumbles upon the leading front of the flatbed and also will certainly simply break out.
5). Checking out the leading left side of the flatbed, on the paper leave side eliminate both screws that hold the scanner carriage lock cover.
6). Encountering the back of the printer, eliminate the screw on the much left which is the appropriate side scanner cover.
7). Shut the leading cover and also eliminate both screws from the top which hold the left scanner cover in position. Make use of an allured screwdriver to stay clear of going down these 2 screws. There is a springtime situated near the back of this cover that is not restricted. Make sure not to shed the springtime when getting rid of the cover.
8). Currently you will certainly see a steel plate with a collection of openings in it. There are 3 openings that are bigger than the remainder which’s where the 3 screws will certainly require to be eliminated from.
9). Encountering the back of the printer, eliminate one FFC (level adaptable cord), and also the adapter to left of it on the scanner control panel.
10). Encountering the front of the printer, slide the scanner somewhat to the right and afterwards raise it up off of the printer. CARE: Make certain you do not launch the scanner lock while the scanner setting up is eliminated. The gas shocks that sustain the scanner setting up can harm the sheet steel scanner setting up system if the system is elevated when the scanner setting up is not mounted.
When you prepare to re-install the scanner make sure to line up the mark on the scanner setting up with the mark on the control board to properly place the scanner setting up. With the scanner setting up properly placed on the sheet steel system, slide the setting up towards the left side of the MFP till it secures right into location.
